Transom-Mounted Units
Home > Products
> Propulsion
Units > Hydraulic
> Transom-Mounted
Transom-mounted units are ideal for applications where sufficient
freeboard is available. They can be welded to the transom
or sides of vessels, barges or platforms. Frequent immersion
from wave action is no problem. The engine and hydraulic
power unit may be installed on deck or in an engine room at any
convenient location. A single engine may power multiple
transom-mounted thrusters.
Contact our Sales Department
for a proposal tailored to your application requirements or request
our AutoCAD drawing CD-ROM for
drawings of various sizes and configurations.
THRUSTMASTER Transom-Mounted AutoCAD Drawings
The “Thrustmaster” is recommended for dynamic
positioning applications, double-ended river ferries and similar
applications where thru 360 degree steering is required. It uses
a multi-port hydraulic swivel assembly and hydraulic motor powered
slewing drives for steering.
TILT - Hydraulic swing up of the outdrive leg
LIFT
- Vertical Hydraulic power depth adjustment
Please note that these drawings are for illustration purposes
only. Please contact your Project Manager about details for your
specific application.
WORKMASTER Transom-Mounted AutoCAD Drawings
The “Workmaster” is recommended for general propulsion
applications. Since the propeller can run in reverse as easily
as it runs in forward mode by virtue of the over-center hydrostatic
transmission drive, the “Workmaster” is capable of
directing thrust in any direction of the compass. It uses a hydraulic
actuator for steering and is simpler and less expensive than
the “Thrustmaster”.
TILT - Hydraulic swing up of the outdrive leg
LIFT
- Vertical Hydraulic power depth adjustment
Transom-Mounted Unit Photos
|